The structure of the window should be able to control sunlight exposure and limit the area ratio of the window wall. For buildings with larger window area, endothermic glass, heat reflection glass or shading measures should be considered, such as sunshade panels, eaves, eaves, balconies, blinds, curtains and so on. Natural air can be directly used as a source of energy when the outdoor temperature is low, so the structure of the window should be able to open or set a natural vent on it.
It is easy to cause the front end of the dashboard to tap the glass and produce abnormal noise. At this time, adding a sponge strip between the two can prevent the occurrence of abnormal noise and prevent small objects such as coins from falling into the car from the front of the dashboard. The most practical configuration: rotating sunshade, front sunshade most car owners may only know the normal telescopic function.
In a good greenhouse, it also requires careful daily maintenance. It takes longer to use it. The covering material of the multi-span greenhouse is generally sunny board or glass, and the thermal insulation performance is also very good, but the interior of the multi-span greenhouse is also equipped with heat preservation measures, which is called internal heat preservation in the industry, which is a very thin waterproof quilt. It is different from the heavy quilt in the solar greenhouse. The multi-span greenhouse thermal insulation is installed at the top and around the indoor, and the multi-span greenhouse adopts the form of internal thermal insulation. The configuration of the multi-span greenhouse belongs to the greenhouse industry, and both external sunshade and internal thermal insulation are configured. Places like the northeast have to be equipped with internal thermal insulation. But it is not called thermal insulation, the thermal insulation of the traditional solar greenhouse is covered outside the greenhouse, but the thermal insulation of our multi-span greenhouse is inside the multi-span greenhouse, and the general installation location is at the top.
The design of the right body is simple, open the door, and there are electric pedals below to facilitate passengers to get on and off the bus. The door is equipped with a pull-type stove with a single-eye stove, which can independently control the size of the fire, improving the portability of outdoor use and increasing the viewing. The upper area is a double-door cabinet where passengers can place kitchen condiments for outdoor picnics. Above the door is a sunshade for the RV, which extends the awning to better shade and block the light, while expanding the scope of outdoor picnics. The saloon car has a special water injection port to solve the problem of receiving water for passengers.
The solar radiation through the transparent enclosure is an important reason for the increase of indoor temperature. The installation of external shading facilities at the transparent enclosure structure can effectively reduce the heat gain of radiation. The sunshine analysis was carried out by using Ecotect software, and the best sunshade angle and sunshade width were obtained. The influence of solar heat gain coefficient of wall on building energy consumption is analyzed by Equest, and the optimal solar heat coefficient is determined.
Now? Some cars are equipped with CD equipment, and the main factors that affect the normal work of car audio in autumn are high temperature and humidity. Because of the car stereo? Installed in the upper part of the dashboard, the sunshade is more effective in order to avoid the exposure of the sun. If the door and window sealing strip is not strict, it should be replaced, otherwise the loudspeaker is easy to rust and damage, or even cause? The road burns down the mainframe.
The sunshade can be used not only as a cosmetic mirror but also as a sunshade, which is its main function, but many people may not have heard of it, but its function is to block the sun on the side. if you put its moving feet down, its sunshade area will become very large.
The sunshade on the dashboard has been completely removed, the center console has become flatter, and the front view has been further improved; both the main and passenger positions are equipped with tuyere cup holders, which is a classic design from the second generation model (the third generation flying degree is only provided by the main driver side). In addition to the traditional glove box, there is a small independent locker on the center console on the side of the co-driver-this is not a high-tech configuration, but it improves the practicability of the whole vehicle.
The car key door can be pulled out in two different gears, one of which is powered by a CD player. I just got it and changed a battery when I ran out of power. When I first got it, there was a noise in the back of the rear seat, the right rearview mirror was loose, the electric adjustment of the rearview mirror was out of order, and the speedometer did not work (this fault was cured by myself after changing the battery). The brightness of the gear display light is very low (the CD player does not read the disc smoothly, the front fog lamp is not bright, the rearview mirror reading lamp and the sunshade make-up mirror light are not lit (the wire is not connected when the front car owner is packing the ceiling), and the right front window rises slowly. Valve cover and steering assist tubing seep oil.
